Datalogic Gryphon D4100 F12 Setup For Barcode Scanner

Created by Datapel Integration, Modified on Fri, 6 Jun at 4:14 PM by Datapel Integration

Description

To improve Barcode Scanner support, a special F12 terminating is added to each barcode scan. This is a custom configuration and must be completed for each new scanning unit added to the system.

Detail Steps

STEP 1. Plug scanner into the USB port.

STEP 2. Wait for the computer to recognize it and report it ready for use.

STEP 3. On the page referenced below there is a sequence of rules that must be followed.

STEP 4. Scan the barcodes in the following order:-

Scan Enter Programming Mode
—— Wait for flashing Scan Light —–
Scan Global Suffix
Scan Code 9.
Scan Code 0.
Scan Enter/Exit Programming Mode.
—— Wait for a confirm beep from scanner —–

Related Information

See attached files for more information, other combinations of Suffix/Prefix and Programming Notes for Suffix/Prefix Settings.