Cordless scanner Gryphon 4100 Series Prefix/Suffix Reference Guide

Created by Datapel Integration, Modified on Fri, 6 Jun at 4:14 PM by Datapel Integration

Description

This document explains Cordless scanner Gryphon 4100 Series Prefix/Suffix setup.

Prefix/Suffix setup:

If less than the expected string of 20 characters are selected, scan the ENTER/EXIT barcode to terminate the string.

Scanned barcode data:12345
Resulting message string output: $12345

Workflow Restrictions

This option sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF.
To configure this feature, scan the ENTER/EXIT barcode to place the unit in
Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” barcode followed by the digits (in hex) from the Alphanumeric characters in Appendix E, Keypad representing your desired character(s).
If less than the expected string of 20 characters are selected, scan the
ENTER/EXIT barcode to terminate the string.

Reference the section, "Example: Setting a Prefix" on page 108, for more information.
Exit programming mode by scanning the ENTER/EXIT barcode once again.

Attached pdf file